The NC515 Programmer is designed to allow installers to both install and reprogram the NC505 Additional Receiver and its associated transmitters for the Tek-CARE®500 Wireless Emergency Call System. The NC515 Programmer obtains its power from the NC505 Additional Receiver, requiring no batteries or additional power supplies. The NC515 connects to the NC505 via a built-in cable that stores inside the NC515 when not in use. The NC515 Programmer is used to program transmission devices for use with the NC505 Additional Receiver.
7.00"H x 4.00"W x 1.50"D
|Construction:||Beige plastic housing|
|Connections:||6' (1.8m) built-in cable|
|Power:||Supplied by NC505 Receiver|
The NC515 Programmer shall set up and program the NC505 Additional receiver for the Tek-CARE®500's Wireless Emergency Call System. It shall connect to the NC505 via a self-contained cable and shall require no external power supply. It shall provide both setup programming and non-destructive review of existing programming. The NC515 Programmer shall have a sealed keypad for resistance to dirt and moisture such as might be encountered through normal indoor handling. The NC515 shall be used to program only the NC505 and associated transmission devices.
TekTone® has designed the Tek-CARE®500 to work as a system. Its NC501 Master Station Computer has been carefully designed and matched to work with Tek-CARE®500 wireless and wired peripherals. TekTone® will not warrant or support components of Tek-CARE®500 that are purchased separately unless the components are add-ons to previously sold systems. TekTone® will also not warrant or support a system that is a mix of TekTone® and Non-TekTone® parts, unless prior written permission has been obtained. Inorder to track our systems and to inform facilities of software upgrades, full site information (site name, address and phone number) will be required when ordering. Site information and NC501 warranty number will also be required when requesting technical support.