Product Specification Sheet APS1132

Rev. 08/2019

ABL-VOIPLCC 4G Cellular Interface Adapter (AlphaRefuge™ Series)

Architects' And Engineers' Specifications

The 4G Cellular Interface unit(s) shall be Alpha Communications® ABL-VOIPLCC  AlphaRefuge™ Series, or approved equal.

The ABL-VOIPLCC  shall mount in a suitable location and shall be powered by a standard 120vac electrical outlet. When used with the AlphaRefuge™ Series Area of Refuge system(s) the unit shall be powered by the PWRAPC power supply and battery back-up unit.

The ABL-VOIPLCC shall come with the required cellular antenna and the antenna shall be installed in a suitable location.


Contractor shall observe all local and national electrical and building codes.


ABL-VOIPLCC 4G Cellular Interface Adapter (AlphaRefuge™ Series)

Features
  • Transmits both voice and data wirelessly
  • Allows you to use up to (2)  elevator phones and the data output from your elevator monitoring device
  • 2100 series phone performs emergency communication failure check and provides “alarm” output when cellular network goes down
  • Places call via IP based cellular accounts. Must setup low cost IP based account with the ALPHA® approved vendor. Also a standard 4G LTE cellular account with either Verizon, AT&T, T-Mobile, or a prepaid account.
  • Requires standard 15mm x 25mm SIM card.
  • Includes (2) FXS ports (RJ11) for phone connection and connection for elevator monitoring device (if monitoring output is phone based, as opposed to IP based, you can only connect (1) 2100 series phone, the other FXS port is for monitoring)
  • Requires 120vac power with battery backup or PWRAPC Power Supply unit
  • Requires two wire connection from elevator phone to cellular device and either two wire or ethernet from elevator monitoring device
  • Surface mounted usually in machine room or location with strong signal
  • Includes cellular antenna
  • VoIP Protocols: SIP v2, SDP, RTP, and RFC 2833
  • Network Protocols: IPv4, TCP, UDP, DHCP, SNTP, STUN, HTTP, and PPPoE
  • Connections: FXS RJ11, LAN, and WAN RJ45 (10/100 BaseT)
  • Power: 120vac from a backed up source or use PWRAPC Power Supply unit
  • Power consumption: 8w
  • Wall mount enclosure with door
  • FCC Part 15 compliant
  • Temperature range -40F to +122F (-40C to +50C)
Specifications
Dimensions:

10.00"W (254mm) x 11.50"H (293mm) x 5.00"D (127mm) total depth

Alpha Communications
42 Central Drive • Farmingdale • NY • 11735-1202 • Phone: (631) 777-5500 • Fax: (631) 777-5599
TOLL-FREE: (800) 666-4800 • Web: www.alphacommunications.com • Email: info@alphacommunications.com
Copyright© 1998-2020 Alpha Communications® - All Rights Reserved.
Due to continuous product improvement, all colors, sizes, materials, finishes and specifications are subject to change without notice.