The outdoor remote station(s) shall be Alpha Communications® model XOR501B2 or approved equal. Station faceplate shall be 2mm thick aluminum in a natural anodized finish. A single momentary action, plastic pushbutton shall be provided for calling function. The pushbutton shall provide two (2) sets of independent contacts, with pigtail wire connections. The speaker / microphone shall be a 2.50" (64mm) high-sensitivity mylar plastic cone type with excellent voice-frequency response. The speaker shall be protected by a high-impact ABS plastic speaker grille. Pigtails shall be provided for all wiring terminations. Station(s) shall fit over a model IH101 (flush) or IH700G (surface) back box. The XOR501B2 station shall be installed with Scrulox (Roberts head) type vandal-resistant screw fasteners, included with the station.
Contractor shall supply a model S1 screwdriver to the building owner for future system maintenance. Contractor shall observe all local and national electrical and building codes.
The Alpha Communications® XOR501B2 outdoor remote intercom stations are designed specifically for applications requiring a call button with two (2) sets of independent contacts. Made from solid extruded aluminum, in a natural anodized finish, these stations are built to last. A high sensitivity 2.50" (64mm) mylar plastic cone speaker assures crisp, clear voice communication, and resists mold and mildew caused by dampness on paper cone speakers. The built-in plastic push-button provides two (2) independent contacts when depressed. This allows the remote station to activate two (2) separate signaling devices simultaneously. A high-impact ABS speaker grille protects the speaker.
When used with the SM201B, SM202, SM203B, SM205, SM210, SM401, SM404, SM406 or SM411 (series) master station(s), a model EC105 non-polarized capacitor must be installed into the XOR501B2 remote stations.
||5.00"W (80mm) x 7.00"H (178mm) x 1.00"D (25mm).
||2.50" round (64mm), 45 ohms, mylar plastic cone, designed for crystal-clear voice.|
||Momentary plastic call button, with two (2) independent sets of contacts|
||Solid Extruded Anodized Aluminum, in Natural Anodized Finish.
||Flush or Surface. Pre-punched mounting holes.
||Model EC105 capacitor. Required when using the XOR501B2 with our SM200 and/or SM400 series master stations. Model S1 screwdriver, used install XOR501B2 onto back box.